In any manufacturing setup the UNC thread gages and UN thread taps are subjected to a very high level of wear and tear. Due to the high level of wear and tear, you will be required to replace your tools frequently. You cannot continue using these tools even after they are worn out. In case of thread gauge, it is an inspection tool and if it is worn out then the accuracy level of the threaded components cannot be determined correctly. This will render the entire process useless. In case of thread taps, the final quality of the threads tapped will depend on the quality of the thread taps. If you are going to continue using a thread tap that does not have clean profiles then the threading quality will also be poor.

To minimize the wear and tear level when using your UN thread taps and thread gauges you need to follow certain basic precautions. In case of the thread gauges, always get a calibration certificate from a third party lab. This will ensure that you are getting an accurate thread gauge. Do not drop the thread gauges while using the tool. Always clean the tool before and after use. If you do not clean the tool before and after use, there will be residual particles on the profile of the tool and it will add unnecessary friction while using the tool. When the friction increases the wear and tear will increase too.

With regard to the thread taps, you should know what is the total number of components that could be threaded with a single tap tool. Make sure that you keep the thread taps well protected from unnecessary wear and tear by lubricating the tool adequately and by using the correct coolant during the thread tap process. Here again, you need to clean the tool before and after use. Most importantly, select the right type of thread tap tool based on the material on which you need to tap thread.

These are some of the most important basics to remember to keep the wear and tear levels under control. Even if you are not familiar with the use of these tools, it does not matter. Just remember the above factors. Select a skilled technician to handle the tools so that you get the best out of these tools.